DRIVERS FOR TSC TDP 245 PLUS

Feed the label, printing side facing up, through the label guide and pass over the platen. Replace the PCB or replace a new lower cover. Open the printer top cover. Fasten the copper pillar and plastic pillar. Select the PC interface connected with bar code printer. Remove the feed button from top cover. Remove 4 screws on PCB.

Uploader: Mashicage
Date Added: 25 May 2015
File Size: 41.25 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 29314
Price: Free* [*Free Regsitration Required]

Loading Label In Cutter Mode 3. Squeeze two sides of platen assembly and take it out. Lead the liner paper through the label opening of peel off module, which is beneath the roller. Insert a paper roller into a paper roll tsc tdp 245 plus.

Page 36 Use tsc tdp 245 plus screwdriver to screw off 1 screw on the bottom. Olus the RJ45 connector daughter board upon the plastic and copper pillar. LED does not light on. Printer initialization is activated by the following procedures.

Use a screwdriver to remove 6 tsc tdp 245 plus p,us the top inner cover. Plug the connector red of peel-off assembly at the location JP19 on the main board. Select the PC interface connected with bar code printer. Page 37 Reassemble parts in reverse procedures.

Related Drivers  ELITE 2540P DRIVER FOR WINDOWS MAC

Fasten the copper pillar and plastic pillar.

Insert the screw of hinge holder Insert the here screw of hinge holder here Remove 6 screws on the lower inner cover. Peel-off Installation option Assembly 3. DO Tsc tdp 245 plus use medical alcohol, which may damage the printer head.

Barcode Printer TSC TDP-245 Plus

Feed the label, printing side facing ttdp, through the tsc tdp 245 plus guide and pass over the platen. Dump Mode Dump mode Printer will enter dump mode after printing printer configuration. Upside down the lower inner cover.

Dump mode Printer will enter dump mode after printing printer configuration. Remove 6 screws on lower inner cover.

TSC TTP Plus – MANICON TECHNOLOGY LIMITED

Gap Sensor Default setting. Page tsc tdp 245 plus Label loaded completely in peel-off mode Change the power adaptor if 24V DC is not been measured. Replace the label guide assembly. Break through the plastic partial tab at the rear side of lower cover to get the RJ45 interface opening. Cutter Module Installation Option 2. Replace the PCB or tsc tdp 245 plus a new lower cover. Release the button when LED becomes amber tsc tdp 245 plus blinking. Please use one of following material to clean the printer.

Related Drivers  EP-4103DL DRIVER FOR WINDOWS 7

Page 11 Label Spindle, fixing tab x2, 1. Remove the front panel from the lower cover. Measurement, Any amber will do during the 5 blinks. Remove 3 screws on lower cover. Printer tdp Plus 1. Self-test printout can be used to check if there is any dot damage on the heater element, printer configurations and available memory space. Stepping Motor Assembly 6.