Turn off the power switch. Use a screwdriver to screw off 1 screw on the bottom. Ground wire Screws RJ45 connector daughter board 4. Printer initialization is activated by the following procedures. Remove 2 screws from the stepping motor assembly; disconnect the stepping motor from stepping motor bracket. The ground wire from the mechanism must be screwed on the daughter board at copper pillar. Page 14 Force Gap Sensor 1.
|Date Added:||28 July 2009|
|File Size:||66.49 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
United States and many other countries See details. Screws Fsc Remove 6 screws from lower inner cover Table of Contents Add to my manuals Add.
Press right slot of the print head bracket and use a flat screwdriver to stick left side of the printer head bracket then pick up the print head assembly. Release notes Sowftware latest release notes Release version Release description Ver.: Using this fdp-245 tool, you can explore the printer tsc tdp-245 plus and settings tsc tdp-245 plus troubleshoot the printer.
TSC TDP Plus – Labelzone Blog
Internal Ethernet Interface Installation option 3. Remove the screw from the main board.
It prints test label to help user adjust printer settings correctly. Reassemble parts in tsc tdp-245 plus procedures. Printer tdp Plus 1. Lower inner cover Lower cover 1. Gap Sensor Default setting.
Peel-off Tsc tdp-245 plus option Assembly 3. Remove 2 screws from the stepping motor assembly; disconnect the stepping motor from stepping motor bracket. Upside down the lower inner cover.
TSC TDP – Plus, Print Head (PDOTSCP-PH) | AM Labels
Gap sensor is set as default, so there is no extra setting for gap sensor. Delivery times may vary, especially during peak periods. Fasten the tsc tdp-245 plus pillar and plastic pillar. NiceLabel driver can obtain the feedback of the printer status.
Replacing Print Head Module Assembly 3. Remove the front panel from the lower cover.
Is there any pre-printed logo on the label? Mar 30, tsc tdp-245 plus Replacing Platen Assembly 3. Use a screwdriver to remove 6 screws on the top inner cover.
Estimated on or before Thu. Page 33 – install sd memory card Page 34 Page 35 – peel-off installation option assembly Page 36 Page 37 Page 38 – loading label for peel-off mode tsc tdp-245 plus Page 39 Page 40 – cutter module installation option Page 41 Page 42 – loading label in cutter mode Page 43 – internal ethernet interface installation Sign rdp-245 for more lists.
TSC TDP-245 Plus Service Manual
Remove two screws in lower cover for hinge holder. Power Switch Rear Paper Guide Don’t show me this message again.
txp-245 Printer initialization is activated by the following tsc tdp-245 plus. Hold the lower cover and lift up the top cover open levers to separate the lower inner cover and the lower cover. Summary Of Board Connectors 2. Replacing Platen Assembly 1.